Caulks & Sealants

Application Guidelines

24 oz. - Dispensing Unit Only Application Method:

Shake well, attach the container to X-TREME Dispensing Unit and begin dispensing. The Dispensing Unit can be metered by pulling the trigger for the desired rate, or with the metering screw located in the back. FILL CAVITY 1/3 FULL. FOAM WILL EXPAND TO FILL CAVITY. Foam application can be interrupted when needed as outlined in the instructions and the Dispensing Unit will be ready for immediate re-use, as long as it remains attached to a pressurized container. An empty gun foam container must be replaced with a new container.

12 oz. - Straw Foam Application Method:

Shake well, attach the straw, invert the container and begin dispensing. By activating the adapter lever carefully, the extrusion rate can be regulated. FILL CAVITY 1/3 FULL. FOAM WILL EXPAND TO FILL CAVITY.

Working Surfaces:

Surfaces must be clean, dry, free of loose particles, and free of dust, grease, and mold release agents. It is the sole responsibility of the user to thoroughly test any proposed use with all substrates to determine project suitability prior to using product on your application.

Method for Containment:

Uncured product is very sticky; carefully remove the bulk of the foam by scraping it up and then immediately remove the residue with a rag and solvent such as X-TREME Cleaner, mineral spirits, acetone (nail polish remover), paint thinner, etc. Once the product is cured it can only be removed mechanically by scraping, buffing, etc. Use appropriate PPE.

Method for Cleanup:

Scoop up material and place in a disposal container. Dispose of as plastic waste in accordance with all applicable guidelines and regulations. Vapors can accumulate in low areas. Provide ventilation.

Coverage:

24 ounce Gun Foam Canister = 1.5 cubic feet per canister
12 ounce Straw Foam Canister = 0.68 cubic feet per canister

Limitations:

• This product is extremely flammable when dispensing.
• Carefully review cautions.
• Optimum temperature for use is between 65° - 80°F (18° - 27°C).
• Clean oil, dust and grease off surfaces to be foamed.
• Make sure to cover surrounding surfaces.
• Wear appropriate safety glasses, gloves and protective clothing. Consult SDS for product safety information.

For questions, please call our Help Line at 1.800.347.4583 or visit us at Titebond.com.