Caulks & Sealants

Application Guidelines

Application Temperature:

Above 40°F (4°C)

Service Temperature Range:

-40°F to 180°F (-40°C to 82°C)

Method of Application:

Cartridge/caulking gun

Working Time:

Approximately 15 minutes for a 1/4" bead

Application Directions:

1. Surfaces must be clean and free of any material that may prevent adequate adhesion. Properly designed joint depth is half as thick as width but not to exceed ½ inch thickness (on joints over 1 inch wide). 2. Cut tip at 45° angle to desired bead width and place in cartridge gun. 3. Force sealant into clean joint. If necessary, smooth bead immediately. It is the sole responsibility of the user to thoroughly test any proposed use with all substrates to determine project suitability. NOTE: If using as an adhesive, bracing may be required until the product dries. Mechanical fasteners should be used for heavy loads.

Cleanup:

Clean uncured material with water. After curing, excess sealant must be cut or scraped away.

Coverage:

Container	1/8” Bead	1/4" Bead	3/8" Bead	1/2" Bead
10.1 oz. Cartridge	123 ft.	31 ft.	14 ft.	8 ft.

Limitations:

Not designed for continuous submersion or use below the waterline. Air, sealant and surface temperature should be above 40°F. Do not apply if rain is expected within 12 hours. Cure time is dependent upon ambient conditions including temperature and humidity. The sealant should be dry to the touch and ready to paint in 2-4 hours. Do not use for aquariums. It is highly recommended to use backing material. For best results, store in a dry location at or below 75°F. NOTE: Titebond UA 920 Clear (8741) will be white during application but will clear within 7-14 days, depending on temperature, humidity and bead size.

50 Year Limited Warranty: If not satisfied with product performance when used as directed, return container and proof of purchase to Franklin International, Inc. for replacement of product. Liability is limited to product replacement only.