Caulks & Sealants

Application Guidelines

Application Temperature:

Above 40°F (4°C)

Service Temperature Range:

-25°F to 180°F (-31°C to 82°C)

Method of Application:

Cartridge/caulking gun

Working Time:

Approximately 10-15 minutes for a 1/4" bead

Application Directions:

1. Surfaces must be clean and free of any material that may prevent adequate adhesion. Properly designed joint not to exceed 1/2" in width. 2. Cut tip at 45° angle to desired bead width and place in cartridge gun. 3. Force sealant into clean joint. If necessary, smooth bead immediately. 4. Do not allow foot or vehicular traffic on repaired area until it is completely dry. It is the sole responsibility of the user to thoroughly test any proposed use with all substrates to determine project suitability. NOTE: Two layers of Blacktop Repair, 1/4” to 1/2” thick that are allowed to dry thoroughly between applications, are better than one heavy layer.

Cleanup:

Clean uncured material with water. After curing, excess sealant must be cut or scraped away.

Coverage:

Container	1/8” Bead	1/4" Bead	3/8" Bead	1/2" Bead
10.1 oz. Cartridge	123 ft.	31 ft.	14 ft.	8 ft.

Limitations:

Not designed for continuous submersion or use below the waterline. Air, sealant and surface temperature should be above 40°F. Do not apply if rain is expected within 12 hours. Cure time is dependent upon ambient conditions including temperature and humidity. The sealant should be dry to the touch and ready to paint in 2-4 hours. Allow to cure for 24 hours before direct contact with water. Wait 24 hours prior to coating with an asphalt or tar based driveway sealer. For best results, store in a dry location at or below 75°F.